Meth Synthesis W/ephedrine, Red Phosphorus
by Cousin Singe
NOTICE: TO ALL
CONCERNED Certain text files and messages contained on this site deal with
activities and devices which would be in violation of various Federal, State,
and local laws if actually carried out or constructed. The webmasters of this
site do not advocate the breaking of any law. Our text files and message bases
are for informational purposes only. We recommend that you contact your local
law enforcement officials before undertaking any project based upon any
information obtained from this or any other web site. We do not guarantee that
any of the information contained on this system is correct, workable, or
factual. We are not responsible for, nor do we assume any liability for,
damages resulting from the use of any information on this site.
All you
people who want an easy meth systhesis - They don't exist! You have to know
some chemistry. Learn some (yes it takes some discipline) or be doomed to fail.
So, again, this
information is posted for information purposes only. I accept no responsibility
for anyone actually using this. If you do you will be subject to state and
federal laws and will be subject to fines and/or imprisonment. If you are
stupid enough to actually manufacture meth you WILL probably go to prison. This
is the 90's.
So to make
meth from ephedrine- Using l- or pseudo ephedrine place 1000 gms of ephedrine,
250gms of red phosphorus, and 1000ml of hydriotic acid in a suitable round
bottom flask. Fit the flask with a reflux condenser and reflux the mixture for
48hrs at 120 degrees C. Add a 10% solution of sodium hydroxide until the Ph is
14. You should get an oil layer and a water layer. Separate the oil layer in a
separatory funnel and put it a flask with 3 volumes of water. Rig the flask for
distillation and distill the oil water mixture until the oil is mostly gone
(except for highly colored globs of oil.) In the reciever flask there should be
two layers, an upper oil layer and a lower water layer. Separate the oil layer
and mix it with 10% hydrochloric acid until the Ph is 7.6. evaporate the water
and it will crystallize into methamphetamine hcl.
------
"We have
observed that mixtures containing red phosphorus, iodine and either
concentrated HCl or glacial acetic acid do convert ephedrine to
methamphetamine; however, when the phosphorus is omitted, methamphetamine is
not formed. Ephedrine was reacted with red phosphorus and iodine in refluxing
water, varying the ratios of red phosphorus and iodine; when red phosphorus and
iodine are in excess of ephedrine in a 1:3.8:7.2 molar ratio (ephedrine:red
phosphorus:iodine) methamphetamine is formed and the ephedrine is consumed in 8
hours."
Anyone have
any thoughts, experience with the typical E-RP-HA when the usually separate
step of creating the hydriotic acid is omitted and the three chemicals are just
reacted in refluxing water. It seems like that is what is being described
(along with acid substitution).
------
Materials:
1. 30ml
bottle tincture iodine containing 2% iodine, sodium iodide 2.4%, alcohol 47%,
rest H20
2. 5 Sinustop
Herbal Decongestant tablets containing 60mg crystaline pseudoephedrine HCl each
mixed with some herbal ingrediants. Or 300mg of ephedrine obtained thru some
other method.
3. 5 road
flares.
4. Bottle of
drain cleaner containg conc. H2SO4
5. Bottle
white distilled vinegar
6. Red devil
Lye containing sodium hydroxide
7. Spray can
of brake cleaner containing 1,1,1 trichloroethylene or 1,1,1 trichloroethane
Procedure:
A. Purifying
pseudoephedrine:
1. Take the 5
decongestant capsules, empty their contents into a small funnel with a coffee
filter. Pour 50ml of cold water through the filter, and collect the liquid in a
small jar.
2. Add a
1/4tsp of lye to the collected liquid. You should immediately smell the odor of
ephedrine.
3. Put the
resultant solution in another small jar, and add 50ml of brake cleaner, then
close the lid and shake vigorously. Let stand so that the layers seperate.
4. Using a
turkey baster, suck up the bottom brake cleaner layer out of the jar and put it
into a small bowl.
5. Add 50ml
of vinegar and heat the resultant mixure over low heat in a frying pan with 1/2
inch of water. Thus a water bath. Do not use a gas stove, since the brake
cleaner vapors will produce toxic phosgene if there is contact with a flame.
Instead use a hot plate or electric stove at low heat only.
6. Heat the
bowl in the water bath until no more liquid is left. At the bottom will be a
solid layer of a pseudoephedrine acetate.
B. Preparing
the red phosphorus:
1. Scrape the
red phosphorus off of the caps of the 5 flares and store for later use. You
should get about 0.1g per flare.
C. Preparing
the iodine/HI solution:
1. Pour the
entire bottle of the iodine tincture into a small ceramic bowl. Heat on the
above type water bath until no more alcohol is left. Let cool, put in a small
polyethylene jar, and add 0.1ml of the H2SO4 drain cleaner. Thats about 1/4inch
of liquid in the end of an eye dropper. This converts the sodium iodide to HI.
You now have a solution of iodine and HI. 2. Add the red phosphorus, and heat bottle
in a water bath until the purple iodine color goes away.
D. The
reaction:
1. Add the
pseudoephedrine acetate to the solution of HI/I and phosphorus, and heat on a
water bath for 24 hours.
E:
Extraction:
1. Cool the
reaction solution and add 1/2tsp of lye. Take the solution and perform steps A3-A6. 2.
You will end up with methamphetamine acetate that you can scrape from the bowl.
Congradulations!
You have circumvented all of law enforcement and have greatly contributed to
the end of the "drug war". (or contributed to the outlaw of all
flares, iodine tincture, vignegar, drain cleaners, and auto store chemicals and
coffee filters as will happen in the next year)
Best regards,
Cousin Singe
------------
FAQ fodder...
If
methamphetamine looks waxy or oily, it is probably contaminated with the HI
salt of meth, an oily by-product of the red-phosphorous/HI reduction of
ephedrine--the most prevalent method of clandestine manufacture.
The HI salt
is soluble in acetone, while the HCL salt is only very slightly soluble. The
HI salt could be washed out, basified, and
then precipitated with HCl gas to give methamphetmine HCL.
When
completely dry, methamphetamine HCL is soluble in chloroform, while ephedrine
HCL is not. This would provide a convenient method of separation.
[Reference:
Skinner, Harry F., "Methamphetamine Synthesis Via Hydriotic Acid/Red
Phosphorous Reduction Of Ephedrine," Forensic Science International, Vol
48, 1990, pp. 123-134]